MX200 standalone behind a DSL router

[ambi]

 I need to deploy a standalone MX200 (non registered) connected behind a DSL router and want to make calls via H323. What sort of configuration is needed for this to work ?

Will it be similar to an EX90 setup in the same way where we set the port allocation to static and setup the H323 nat address 

Where are these configuration options to set on a MX200

Thanks

Ambi 

[Patrick Sparkman]

Hello Ambi -

I looked at the datasheet for both the MX200 and MX200 G2, and they both said they support H.323.  So, you should be able to do this, just be sure to open the appropriate ports in the firewall and set the H.323 ports to be static instead of dynamic.

[Wayne DeNardi]

HI Ambi,

Yes, the MX200 runs the same software as the EX90 you mentioned as well (TC software) - so the way it's configured is pretty much identical.

If you've got the EX90 working, duplicate similar settings on to your MX, open up the firewall ports, and you should be good.

There are plenty of threads in these forums that describe the ports required and the NAT configuration.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.