Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

MX300 config guide

Hello,

I'm trying to integrate a telepresence unit MX300 with UCM 8.6.2a

I'm not configuring the SIP settings properly on the MX300 unit. it doesn't get registered. I configured the MX300 as a phone

i was wondering if you could share a deployment guide for the MX300

thank you

1 REPLY
Cisco Employee

MX300 config guide

Hello,

You will need to apply the latest device pack to your CUCM (cmterm-devicepack8.6.2.21020-1.cop.sgn) released 28 FEB 2012.

This adds support for the MX300 and SX20 as well as they are new products.  For some reason this is not mentioned in the device pack release notes but apply this and then you should have support for your MX300.

Please read the device pack release notes for how to install.

Thanks

806
Views
0
Helpful
1
Replies