Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Endpoint's name when conference with SX20 Multisite

Hi,

I setup a lab which consist 2 SX20 and 1 EX60. Using SIP and no call control, I try to conference with SX20 multisite capability (just call using prefix@IP). But, I notice there is no name display below each participant in the video. Is that normal behavior? I have configured display name on each endpoint.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Green

Yes, that is normal behaviour

Yes, that is normal behaviour.  The names of the participants will appear when using a MCU, and only if it is configured to do so.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
1 REPLY
VIP Green

Yes, that is normal behaviour

Yes, that is normal behaviour.  The names of the participants will appear when using a MCU, and only if it is configured to do so.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
93
Views
0
Helpful
1
Replies