One Button To Push causes endpoint to call MCU twice
Hi, I have an issue with TMS conferences that use the One Button To Push type of connection. When the endpoints show the Join Meeting prompt, I select Join and the endpoints then dial the conference number twice at the same time. This starts a video call and an audio call at the same time causing an echo. If you hangup the audio call the conference continues normally.
Can anyone shed any light on how the meeting gets setup from TMS or advise what logs to investigate further.
I have CUCM v8.6.2, VCS-c v7.2.2, TMS v14.3.2 and MCU 5320 v4.4. All the endpoints are registered to CUCM. Manual and automatic calls all work ok.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.