Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

precision HD 1080p camera

Hello I am trying  to program this precision  HD 1080p camera via RS232 but I need some help. my com port on the computer is 9600bps

and the camera is too.

Can someone please explain why this code I am sending to it wont  work. 8x 01 04 00 03 ff  I entered this code into puttytel telnet program but it will not control the unit. 

what do I need to do in order to control this unit.

 

Power_On

8x 01 04 00 02 ff

Power control. This command stores the zoom and focus value and reset these motors.

Used for PrecisionHD 720p if the camera has been on for a  long time.

Puts the PrecisionHD 1080p camera to standby mode.

Power_Off

8x 01 04 00 03 ff

1 REPLY
New Member

This discussion has been

This discussion has been reposted from Cisco On Demand to the TelePresence community.

61
Views
0
Helpful
1
Replies