Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Presentation codec frame rate

                   what is the frame rate when I using the PiP as presentation output if I have presenation codec

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Presentation codec frame rate

If using PIP on a CTS 3000 it should be 5FPS.

Using an External monitor your will get 30FPS.

5 REPLIES
Silver

Presentation codec frame rate

Hi Ehab,

I believe the frame rate is 30 frames/second when using a Presentation codec. Sharing a presentation without Presentation codec will trasmit at 5 frames/second.

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar
New Member

Re: Presentation codec frame rate

Hi Ehad

What system are you using?

For the 500, 1100, 1300 CTS systems, 30FPS is not supported in PIP mode.

So I assume it would be back down to 5FPS

Note The high frame rate codec does not support 30 frames/sec in presentation-in-picture (PIP) mode. An external display is recommended.

The TX series however use a software key and not a presentation codec. So 30FPS in PIP mode might be supported on the TX series.

New Member

Presentation codec frame rate

Thank you,

The system is cts 3000.

if we using the PiP in CTS 3000 with presentation codec the frmae rate is 30fps or its down to 5 fps.

New Member

Presentation codec frame rate

If using PIP on a CTS 3000 it should be 5FPS.

Using an External monitor your will get 30FPS.

New Member

Presentation codec frame rate

Thank you very much

458
Views
0
Helpful
5
Replies
CreatePlease login to create content