Problem removing VCS from TMS and migrating to TMSPE
We are getting ready to start using TMSPE, however first we need to disable TMS Agent replication on all VCS's via TMS. There is a VCS that failed and was subsequently removed, but we can't remove it from TMS because TMS Agent replication is enabled. We can't get to the TMS Agent tab to disable replication because the VCS is offline (i.e. it was removed) - it just goes to the "Connnection" tab every time I try.
So how can we migrate to TMSPE if TMS won't let us delete the offline VCS or at least turn of TMS Agent replication for it?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...