Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem with Presentation on MPS 800 using SIP/BFCP

I have a Tandberg MPS 800 registered as SIP to a Cisco VCS

Calling from the MPS MCU to a Cisco T1 and a Cisco MXP 990 both as SIP, so all native SIP.

I cannot send or receive content from either endpoints? The MPS reports no active dual stream and is unaware that any of the endpoints are trying to display content.

It works fine in H323 mode.

MPS is on J4.7

T1 & MXP are both on latest releases.

Any suggestions?

376
Views
0
Helpful
0
Replies
CreatePlease to create content