Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question SX-20 and ISDN Link

Dear Expert

I have a SX-20 with TC6.1.2 and ISDN Link with 1.1

I pair those device with auto pairing. It works fines but each time I power up.

The following screen shows up.

I dont have a touch panel with my system

Is it possible I get rib of that message for boot up

Thank you

Best Regards

Tung Chan

2 REPLIES
Silver

Re:Question SX-20 and ISDN Link

Hi Hon

As you are not using the touch and initially you have paired it so everytime it checks for the touch panel

Please unpair and restart the device and then you can start using the remote.
The message will not be shown on the unit

Regards
Ravi kr..


Sent from Cisco Technical Support Android App

New Member

Re:Question SX-20 and ISDN Link

Hi Ravi

Thank you for your repond!

I never pair the sx20 with touch panel.

I only pair with the ISDN Link.

When I pari with the ISDN Link, the message shows up each time I boot up the SX20.

I try "unpair and restart" but the message still shows up on reboot/power up.

So far the only I can to get rib of it is unpair with the ISDN Link.

It comes back up when I pair with ISDN Link again.

It is weird.

It happen to my other SX 20 pair with ISND Link too.

It is the way to be?

Thank you

Best Regards

Tung Chan

291
Views
0
Helpful
2
Replies
CreatePlease login to create content