Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

"Auto-Pair" Cisco Touch Panel

Can someone please advise a way to "auto-pair" the Cisco Touch Panel if it gets disconnected? We have setup several Touch Panels, paired to Codecs and would like them to automatically establish the pairing relationship if communications get broken with the Codec...is this possible? what configuration should be applied.

At the moment we need to manually re-pair by selecting the codec IP and autheticating the connection...very painful.

Thanks
Matt

2 REPLIES
Community Member

"Auto-Pair" Cisco Touch Panel

Hi Matt,

We have a similar setup, but I have never found a way to auto-pair the panels. Fortunately, ours rarely lose their connection as long as everything stays plugged in.

Cisco Employee

"Auto-Pair" Cisco Touch Panel

I opened a system enhancement a while back requesting the ability      to pair based on hostname as opposed to IP address and have DNS     resolve

the codec's  IP address.

CSCua05282 - Ability to pair touch using other parameter than IP     address

From internal aliases I also came to understand that direct pairing versus pairing over LAN would make the touch auto-pair each time [here we use fixed IP address!].

534
Views
0
Helpful
2
Replies
CreatePlease to create content