Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

"unable to switch between cameras" on 1300

Working on an install on a 1300 running CTS code 1.6.7, trying to tune the cam and getting this error on both left or right cam on loopback when trying to switch them, center works fine.  Any ideas what's going on?  Can't get this thing finished, A/V box is out, got a case open for that as well...

351
Views
0
Helpful
0
Replies
CreatePlease to create content