reload wallpaper on cli

[JensLantermann]

Hi everybody,

I have created a little script, who push the wallpaper via winscp on to the codec.

Path is /users/posters witht the correct naming.

But the endpoint shows me a black screen, the xconfig parameter is set to custom.

So everything is correct, but black.

If I do a call and end them immediatly the new wallpaper will be displayed.

This looks like there is a reload of the wall paper missing.

How can I do that at the cli, without a reboot of the system?

regards Jens

[Patrick Sparkman · Accepted solution]

What happens if you issue the wallpaper command after you upload it, does it refresh then?

xConfiguration Video Wallpaper: Custom

Note: command might be a little off, typing from memory.

Sent from Cisco Technical Support iPhone App

[JensLantermann]

Ok this works not really, but should be a workaroud.

1.xconfiguration Video Wallpaper: Summersky

2.xconfiguration Video Wallpaper: Custom

You must switch to another wallpaper and back to custom.

It is not the answere I was looking for, but ok.

[Patrick Sparkman]

What about not switching to the custom wallpaper until it's loaded?

Sent from Cisco Technical Support iPhone App