03-04-2014 03:54 AM - edited 03-18-2019 02:41 AM
Hi everybody,
I have created a little script, who push the wallpaper via winscp on to the codec.
Path is /users/posters witht the correct naming.
But the endpoint shows me a black screen, the xconfig parameter is set to custom.
So everything is correct, but black.
If I do a call and end them immediatly the new wallpaper will be displayed.
This looks like there is a reload of the wall paper missing.
How can I do that at the cli, without a reboot of the system?
regards Jens
Solved! Go to Solution.
03-04-2014 05:24 AM
What happens if you issue the wallpaper command after you upload it, does it refresh then?
xConfiguration Video Wallpaper: Custom
Note: command might be a little off, typing from memory.
Sent from Cisco Technical Support iPhone App
03-04-2014 05:24 AM
What happens if you issue the wallpaper command after you upload it, does it refresh then?
xConfiguration Video Wallpaper: Custom
Note: command might be a little off, typing from memory.
Sent from Cisco Technical Support iPhone App
03-04-2014 05:34 AM
Ok this works not really, but should be a workaroud.
1.xconfiguration Video Wallpaper: Summersky
2.xconfiguration Video Wallpaper: Custom
You must switch to another wallpaper and back to custom.
It is not the answere I was looking for, but ok.
03-04-2014 06:15 AM
What about not switching to the custom wallpaper until it's loaded?
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: