Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

reload wallpaper on cli

Hi everybody,

I have created a little script, who push the wallpaper via winscp on to the codec.

Path is /users/posters witht the correct naming.

But the endpoint shows me a black screen, the xconfig parameter is set to custom.

So everything is correct, but black.

If I do a call and end them immediatly the new wallpaper will be displayed.

This looks like there is a reload of the wall paper missing.

How can I do that at the cli, without a reboot of the system?

regards Jens

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: reload wallpaper on cli

What happens if you issue the wallpaper command after you upload it, does it refresh then?

xConfiguration Video Wallpaper: Custom

Note: command might be a little off, typing from memory.

Sent from Cisco Technical Support iPhone App

3 REPLIES
VIP Purple

Re: reload wallpaper on cli

What happens if you issue the wallpaper command after you upload it, does it refresh then?

xConfiguration Video Wallpaper: Custom

Note: command might be a little off, typing from memory.

Sent from Cisco Technical Support iPhone App

New Member

reload wallpaper on cli

Ok this works not really, but should be a workaroud.

1.xconfiguration Video Wallpaper: Summersky

2.xconfiguration Video Wallpaper: Custom

You must switch to another wallpaper and back to custom.

It is not the answere I was looking for, but ok.

VIP Purple

Re: reload wallpaper on cli

What about not switching to the custom wallpaper until it's loaded?

Sent from Cisco Technical Support iPhone App

111
Views
0
Helpful
3
Replies