Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restore MX200 to factory default

Hello engineers,

How do I restore the MX200 to factory default by a hardware way? How do I restore with SSH commad?

Regards

Dario

Everyone's tags (4)
2 REPLIES
Cisco Employee

Restore MX200 to factory default

Cisco Employee

Restore MX200 to factory default

Hi,

From SSH use commnad :

xcommand SystemUnit FactoryReset Confirm: yes

You can also reset it by using reset button,

  • TC 4.2.x and TC 5.0.x
    1. Remove the cover on the back of the MX200/MX300
    2. Turn off power and wait  5 seconds
    3. Turn on power, and wait 1 second before pusing reset & hold  until the white LED (over screen to the left of camera) starts to blink  (15-20 seconds)
    4. Push the reset button 2 times as soon as it starts to blink
  • TC 5.1 and later
    1. Remove the cover on the back of the MX200/MX300
    2. Either when powered off or when system is up: Press and hold  for approximately 10 seconds - the screen will go black. The system will  factory reset and come up with a confirmation dialog stating that the  factory reset was succesful.

HTH

kind regards,

Dharmmesh

2743
Views
0
Helpful
2
Replies