Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Routes Commands for Cisco VCS

Hi,

We deployed a VCS Expressway Starterpack with dual NIC.

We followed the deployment guide on how to deploy dual NIC and works fine. 

We find hard on how to show the routes that were configured and also how to delete routes on the VCS. 

What are the specific commands for these?

Thanks for your support in advance.

 

Best regards,

Acevirgil de Ocampo

Everyone's tags (1)
2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Purple

I checked and didn't find a

I checked and didn't find a way to see what routes are currently configured, only the ability to add or delete, unless it's under another command or in UI somewhere.

 

xCommand RouteAdd

"Adds and configures a new IP route (also known as a static route)."
             Address(r): <S: 1, 39> "Specifies an IP address used in conjunction with the prefix length to determine the network to which this route applies."
             PrefixLength(r): <1..128> "Specifies the number of bits of the IP address which must match when determining the network to which this route applies. Default: 32"
             Gateway(r): <S: 1, 39> "Specifies the IP address of the gateway for this route."
             Interface: <Auto/LAN1/LAN2> "Specifies the LAN interface to use for this route. Auto: the VCS will select the most appropriate interface to use. Default: Auto"

 

xCommand RouteDelete

"Deletes a route."
             RouteId(r): <1..50> "The index of the route to be deleted."

VIP Green

"xconfiguration ip route"

"xconfiguration ip route" will show you the routes that are currently configured.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
3 REPLIES
VIP Purple

I checked and didn't find a

I checked and didn't find a way to see what routes are currently configured, only the ability to add or delete, unless it's under another command or in UI somewhere.

 

xCommand RouteAdd

"Adds and configures a new IP route (also known as a static route)."
             Address(r): <S: 1, 39> "Specifies an IP address used in conjunction with the prefix length to determine the network to which this route applies."
             PrefixLength(r): <1..128> "Specifies the number of bits of the IP address which must match when determining the network to which this route applies. Default: 32"
             Gateway(r): <S: 1, 39> "Specifies the IP address of the gateway for this route."
             Interface: <Auto/LAN1/LAN2> "Specifies the LAN interface to use for this route. Auto: the VCS will select the most appropriate interface to use. Default: Auto"

 

xCommand RouteDelete

"Deletes a route."
             RouteId(r): <1..50> "The index of the route to be deleted."

VIP Green

"xconfiguration ip route"

"xconfiguration ip route" will show you the routes that are currently configured.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
VIP Purple

I thought I checked that

I thought I checked that command, but I could have mistyped it or something.  Good catch Wayne.

530
Views
0
Helpful
3
Replies