Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

security error message in a telepresence ex90 !!!!

Hi all

I have a telepresence ex90

it's registered no problem with it except the following message

"Security risk: system password not set please contact the system administrator"

which password !! how can i add it

Thanks in advance

Regards

  • TelePresence
3 REPLIES
Silver

security error message in a telepresence ex90 !!!!

Hi Zaher,

you need to set a custom password on your EX90 unit to remove this security message.

just login in to your EX90 web interface using default password " TANDBERG" and then select admin tab at the top right hand side.

this will give you option to change password.

above security error will also be displayed when password is set to default "TANDBERG" so change it accordingly.

New Member

security error message in a telepresence ex90 !!!!

Hi Amit

Thanks

I can ping it but

I'm unable to access it neither web nor CLI

I found the following tow ways to change it through Web | CLI

Using the web interface

When you know the IP address you can configure the

endpoint from the web interface.

Signing in to the web interface

1. Open a web browser and enter the system’s IP address in

the address bar.

2. Enter your user name and password and click Sign In.

The default user name is adminwith no password set.

Using the command line interface

When you know the IP address you can configure the

endpoint from a command line interface by API commands.

Signing in through SSH

1. Start a command line interface (for example PuTTY).

Enter the host name (or IP address) of the codec and set

connection type to SSH.

2. Log in with the appropriate username and password.

The default user name is adminwith no password set.

3. Issue the commands as described later in this guide.

Is there any further configurations must be done to get the access to it

Thank you

Regards

VIP Green

security error message in a telepresence ex90 !!!!

Depending on software versions, the admin password may be blank (ie no password required), or may be TANDBERG (caps are important).  If you can get in to the web, or CLI as with these details, you should then be able to reset the password to something non-default.

Wayne

--

Please remember to rate responses and to mark your question as answered if appropriate.

1125
Views
5
Helpful
3
Replies
This widget could not be displayed.