Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Serial Number of Tandberg Codec CTS-C60-K9

Hi,

Can anyone tell me how to get the serial number of Tandberg Codec CTS-C60-K9 device.

can this be located on the device and in what format is it written?

Prompt response will be appreciated.

Regards,

Peter Nnaji.

8 REPLIES
Bronze

Re: Serial Number of Tandberg Codec CTS-C60-K9

Hi Peter,

Login as admin on telnet/ssh and type "xstatus systemunit hardware module serialnumber" or login to the webinterface and take a look at the System information page.

Hope this helps.

Arne

Sent from Cisco Technical Support iPad App

Cisco Employee

Serial Number of Tandberg Codec CTS-C60-K9

From physical HW: Check system information bottom of C60 Codec and look for number starting with “SN:”.

From Web GUI: Under System Information (first page after login), you will find “Serial number” fields with 12 digits number (i.e A1AR46B00001).

From Console/SSH: Execute “xsta SystemUnit Hardware Module SerialNumber” then serial number will print out on terminal session.

New Member

Serial Number of Tandberg Codec CTS-C60-K9

Hi Tomonori,

Your response was quite helpful, but one other issure I have with the Codec is that when I power it up, it does not boot completely. it gets to a stage where it shows 'Cisco' and hangs thereforever.

What could be the possible cause for this?

regards,

Peter.

New Member

Re: Serial Number of Tandberg Codec CTS-C60-K9

Hi Tomonori,

i am using it for the first time. Its a new device.

Regards.

Cisco Employee

Re: Serial Number of Tandberg Codec CTS-C60-K9

> it does not boot completely. it gets to a stage where it shows 'Cisco' and hangs there forever.
> i am using it for the first time. Its a new device.
If still facing same booting failure, I’d recommend retrieve application.log from Endpoint (possible to retrieve it by using SSH or WinSCP if prefer GUI operation) or alternatively connect PC from console port and boot up.

Then contact TAC for further investigation.

New Member

Re: Serial Number of Tandberg Codec CTS-C60-K9

Thaank you.

Will try that and get back to you.

Cisco Employee

Serial Number of Tandberg Codec CTS-C60-K9

> it does not boot completely. it gets to a stage where it shows 'Cisco' and hangs thereforever.

Do you start experiencing this recently? (meaning does C60 ever boot up properly and works before and made any change? i.e upgrade software)

Do you have active LAN connection on Ethernet port 1?

New Member

Re: Serial Number of Tandberg Codec CTS-C60-K9

Hi Peternnaji

If the product information printed on the underside of the codes is unreadable and you can’t get onto the system itself to check, try the below.

If the codec was sold with a Cisco camera you can get the codec serial number from the Cisco Licensing site by doing a lookup on the camera’s SN.

The camera should have its product information printed on its underside same was the codec.

      

2142
Views
3
Helpful
8
Replies
CreatePlease login to create content