Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Setup Dual Screen in Cisco Telepresence SX20

Hello All,

 

I have one recently installed SX20 (TC 6.3) . the unit have the following options installed.
 MultiSite / PremiumResolution / DualDisplay
When I make a call to another site and  I´m sending a content,I want to  video screen calls on the left, on the right side of the screen of PC PPT
Does something know how to do this setup?

I am such a set

Go to the system settings, under "Video", "Monitors:, select either "Dual" or "DualPresentationOnly". See below screenshot:

Go to Video Output and set output for hdmi 1 and hdmi 2 to whatever configuration you require; i.e. monitor role first, second, presentation only, see below screenshot:

But set out, the result of the show is like this

How to set up, thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

This should get you what you

This should get you what you want.

Configuration > Video > Monitors > Dual

Configuration > Video > HDMI 1 > First (connected to display on the left)

Configuration > Video > HDMI 2 > Second (connected to the display on the right)

Configuration > Video > SelfviewDefault > FullscreenMode > On

Configuration > Video > SelfviewDefault > OnMonitorRole > Second

The last two options will make the selfview video appear on the second display when presentation content is not being sent.

If that doesn't work, what layout options appear?  Using the remote, it's the button above end call.  I've seen sometimes where the layout choice can affect the appearance of dual displays.

2 REPLIES
VIP Purple

This should get you what you

This should get you what you want.

Configuration > Video > Monitors > Dual

Configuration > Video > HDMI 1 > First (connected to display on the left)

Configuration > Video > HDMI 2 > Second (connected to the display on the right)

Configuration > Video > SelfviewDefault > FullscreenMode > On

Configuration > Video > SelfviewDefault > OnMonitorRole > Second

The last two options will make the selfview video appear on the second display when presentation content is not being sent.

If that doesn't work, what layout options appear?  Using the remote, it's the button above end call.  I've seen sometimes where the layout choice can affect the appearance of dual displays.

New Member

Thank you very much for your

Thank you very much for your answer, I found the cause of the problem, because the new SX20 equipment need to be loaded separately LIC-SX20-DD、LIC-SX20-PR  LIC , so before the configuration is not successful, after loading is ok, thank you very much.

533
Views
0
Helpful
2
Replies