I just received a cisco telepresence SX10 device which uses SIP protocol only and I have no experience at all with this. Older devices that I have worked with used H323 protocol which is very easy to configure. Looking for some assistance on how to setup the SIP. Your help will be greatly appreciated
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.