07-12-2012 06:21 AM - edited 03-17-2019 11:27 PM
Hi,
I am currently setting up interoperability between Cisco VCS-Control X7.1 and CUCM V7.1.3.
The IPT dial plan consists of site prefixes and area codes which make up the phones full DN, this DN is also starts with a #.
E.g #0044014761
My problem is (I think), that # is an unsupported SIP URI character which is stated in the deployment guide. I have attempted to use %35 which is the ASCII value for #; interestingly enough, when using this i can resolve the alias against the CUCM SIP trunk but when attempting to dial from an endpoint, it fails.
I know my SIP trunk is OK, as I can route 9.* calls via it over the CUCM PSTN break-out.
Has anyone come across this issue before, or been able to work around it??
Thanks, Si
Sent from Cisco Technical Support iPhone App
Solved! Go to Solution.
07-12-2012 07:08 AM
For your reference, there was similar (pretty much same) discussion a month ago,
07-12-2012 07:08 AM
For your reference, there was similar (pretty much same) discussion a month ago,
07-12-2012 01:19 PM
Thanks, sorted my problem!
Si
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: