I'd attempt another software upgrade and/or factory reset, if neither of these options resolve the issue, recommend you open a TAC case. Factory reset usually resolves most issues, but of course it should be used as a last resort because it will wipe the configuration etc.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.