Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SX20 and Touch 8 Username/Password

I have an SX20 configured on CM and I am attempting to connect the Touch 8 panel to it via the on-screen pairing on the Touch 8.

I get to a point like many others with the Username/Password prompt.  I've tried everything.. using the admin portal credentials, resetting the SX20 to factory defaults, using admin with no password..

Any help would be greatly appreciated.

Thanks,

Tyson
 

2 REPLIES
New Member

Have you tried admin/123 or

Have you tried admin/123 or admin/1234?

VIP Purple

Your question would be better

Your question would be better placed in the TelePresence section of the forums where these devices are more actively discussed than in the main Collaboration, Voice, and Video section you've posted in.  You can move your discussion by editing your post and changing the categories at the bottom.

Whatever the username/password is for the admin account is what you will use to pair the Touch 8 with.  However, pairing can only be done for a few minutes after the codec has booted up.  Try to restart the codec, and see if you can get it to pair right afterward.

246
Views
0
Helpful
2
Replies
CreatePlease login to create content