Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SX20 main cam output on monitor 1 and monitor 2 at the same time

Hi Community,

we have an SX20 (TC7.0.2) and need to have the main source (12x Cisco cam) on both monitor outputs, because we need to record the VC session.

DD option is installed. Is there a way to get this configured ?

Regards
Jens

Everyone's tags (1)
2 REPLIES
VIP Purple

So you don't want to see the

So you don't want to see the far-end on the screen, just the local camera input?  As far as I know, there is no way to hide the far-end video while a connected video conference session is in progress.  If you were using an MCU or TelePresence Server, you could mute the outgoing video to the SX20, but other than that, don't think what you're looking for is possible.

VIP Green

If you just want to record

If you just want to record what the SX20 sends out to its main monitor to a second screen/recorder, you could just use something like a DA2 to duplicate the audio/video that is played locally.

In addition to what Patrick has said about the video from the local camera though - you're also not going to get the local audio through the monitor output - only the far end - so, again, this may not be what you're wanting if you're looking to record the whole video conference (audio and video from both ends).

I suggest you look in to the Cisco TelePresence Content Server product if you're looking to do recording on a regular basis.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
142
Views
0
Helpful
2
Replies
CreatePlease login to create content