Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SX20 multisite deployement

Hello,

I'm looking for a design based on SX20 and SX10 Telepresence solutiion to provide a Multisite Video conferencing.

The architecture is based on a one central site and two remote offices that are connected to each other via VPN.

 

What are the Telepresence Video Hardware requirements to provide a Multisite/ multi participante solution mixed with SX20, SX10 and Cisco Jabber Video softphone?

 

Kinds regards.blush

 

 

2 ACCEPTED SOLUTIONS

Accepted Solutions

Hi,For SX10 you need deploy

Hi,

For SX10 you need deploy CUCM or VCS for call control.

For multisite call you can use embedded function multisite your SX20.

 

br Oleksandr

br Oleksandr

You can use SX20 on each site

You can use SX20 on each site without deploy CUCM or VCS.

If you need SX10 or Jabber softphone you must deploy CUCM.

Maybe public Jabber www.ciscojabbervideo.com resolve your issue if you don't want deploy CUCM.

br Oleksandr

br Oleksandr
7 REPLIES

What do you have for call

What do you have for call control?

If you have the multisite option on the SX20, you should be able to conference in up to 3 other endpoints. You could also look at a MCU or Telepresence server but that starts becoming expensive. 

Please rate useful posts.
New Member

Hello,We have one CME on a

Hello,

We have one CME on a remote site but other sites including centrale site using legacy PBX.

Can we use a Jabber Video softphone without a CVS or CUCM?

 

Regards

 

Hi,For SX10 you need deploy

Hi,

For SX10 you need deploy CUCM or VCS for call control.

For multisite call you can use embedded function multisite your SX20.

 

br Oleksandr

br Oleksandr
New Member

Thanks Oleksandr,So you need

Thanks Oleksandr,

So you need just to deploy only SX20 for each sites?

 

What about Jabber Soft phone?

 

regards

You can use SX20 on each site

You can use SX20 on each site without deploy CUCM or VCS.

If you need SX10 or Jabber softphone you must deploy CUCM.

Maybe public Jabber www.ciscojabbervideo.com resolve your issue if you don't want deploy CUCM.

br Oleksandr

br Oleksandr
New Member

Thanks for response. Please

Thanks for response.

 

Please how can connect Jabber on jabbervideo.com to SX20 plateforme?

 

Kinds regards

 SX20 must use public IP and

 

SX20 must use public IP and H323  call protocol.

For call from jabber-video to H323-device read: https://supportforums.cisco.com/discussion/12190541/accountjabbercom-call-h323-endpoint

 

br Oleksandr

br Oleksandr
357
Views
0
Helpful
7
Replies