12-12-2013 02:27 AM - edited 03-18-2019 02:17 AM
Bonjour
Je souhaite pouvoir piloter des SX20 mais mais pas en IP et le SX20 ne dispose plus de port RS
Avez vous une solution
Je vous remercie
Olivier
12-12-2013 04:40 AM
Hi Oliver, this is the English version of the support forums.
If you could please translate your question.
Please remember to rate helpful responses and identify helpful or correct answers.
Please remember to rate helpful responses and identify
12-12-2013 06:02 AM
From a quick google translate of your question, it appears that you'd like to control your SX20 via RS232 rather than via IP.
Unfortunately, as a QuickSet product, there is no ability to do this. For such control, you'll need to look at an integrator type codec such as the C40/C60/C90.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Sent from Cisco Technical Support iPad App
Please remember to mark helpful responses and to set your question as answered if appropriate.
12-13-2013 01:13 PM
Should be possible to use a usb2serial cable and do some basic API commands.
There might be also boxes being capable to translate the ssh or telenet of the sx20 to a serial conneciton.
But I would clearly prefer to use ip via ssh or https ;-)
Please remember to rate helpful responses and identify helpful or correct answers.
Please remember to rate helpful responses and identify
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: