cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
172
Views
0
Helpful
1
Replies

SX80 with CUCM 10.5.2

xxy19901123
Level 1
Level 1

Hi

I had a SX80 endpoint registed on cucm10.5.2, when I set the time ,language and the call procotol it worked ,but when I restart the SX80 it was return to the original position, can I save the change but not return to the original position ? Thank you !

1 Reply 1

Atul Gaba
Cisco Employee
Cisco Employee

Check that your persistency settings are configured properly. (Page 43 in the below link)

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/sx-series/tc7/administration-guide/sx80-administrator-guide-tc73.pdf

-Atul

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: