Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

TANDBERG UNIT III NTSC camera cable pinout

ALCON,

Does anyone have a reference document that describes the cable pinout and the cable part number for the old TTC-6 not TTC-7 (MXP6000) codec connection to the TANDBERG UNIT III NTSC (analog) camera???? 

Any assistance would be appreciated.

 

VR

Chet

Chet Cronin
801-815-3539(USA)
801-815-3539 (AFG)
1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Hello Chet,Here is a link to

Hello Chet,

Here is a link to get the Tandberg MXP user guide

 

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/mxp-series/f8/administration_guide/tandberg_mxp_administrator_guide_f80_august2010.pdf

On page 262, you will see the output pinouts from the 6000MXP codec and page 302 gives you the input pinout on the Camera Wave2.

 

Hope this helps

Steve

1 REPLY
Community Member

Hello Chet,Here is a link to

Hello Chet,

Here is a link to get the Tandberg MXP user guide

 

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/mxp-series/f8/administration_guide/tandberg_mxp_administrator_guide_f80_august2010.pdf

On page 262, you will see the output pinouts from the 6000MXP codec and page 302 gives you the input pinout on the Camera Wave2.

 

Hope this helps

Steve

581
Views
0
Helpful
1
Replies
CreatePlease to create content