The local and remote layouts are created under the same name, but it appears that they are menu selected separately. I would have liked to have both activated together using the layout button via IR remote. Is this correct that the only way the remote layout changes is via the soft-key labeled Remote layout?
Also found the remote layout holds the last selected one even when a new call causes a new default to be active. You need to activate the last used one, then you need to select a different one then reselect the original.
One additional anomaly I have, the custom layouts do not all consistently show up in the menu for local choices. Sometimes more will show up (not in a call) when I rearrange the menu order or when I include a predefined layout (Equal). Note I have three cameras on a C90 and the problem layouts seem to be ones using a single camera. Also when in a call fewer yet local layouts show.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.