TC Console version 6.2 works fine with TC6.3. However, if the layout of codec previously has been modified with an earlier version of TC Console you will see a warning when trying to connect.
Text of warning; Reset broken or unsupported Video Layout component data The Video Layout component data is broken or not supported by this version of TC console. Confirming this action will reset the Video layout component to the factory defaults.
Pushing the Reset choice will delete all previous changes to the layout, resetting back to factory default. Pushing the cancel choice you will not be connected to the codec.
Use the reset choice, and start modifying the layout.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...