TC6/7 can you hid the clock/calender without hiding the OSD?
As Patrick has responded above, no, there doesn't appear to be any way of turning just the clock and calendar off. If this is something that is important for you, I'd suggest you raise a feature request through your local Cisco representative to try to have the ability to do this added to a future software release.
One work around that we use for sites that have units that operate over ISDN is to also connect them to the LAN at that site - they can then get their time from the LAN, as well as provide managment capabilities via the web browser, etc. All calls can still be set to H.320 and go out the ISDN Link. (We do this with some of the older Edge95 devices too - calls over ISDN - management over LAN).
Please remember to rate responses and to mark your question as answered if appropriate.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...