Telepresence MSE 8510 media Blade not sending packets over network
I was wondering if you have seen this problem in the past. My company just recently pruchased two extra Telepresence 8510 Media blades to increase our capcity on our 8000 Chassis. The blades were each installed and configured per the cisco PDF instructions with the same network settings as the old baldes. After setup we are unable to access the new blades through their web interface. When accessing the supervisor blade it states that the new blades is are all "OK" but we still can't access it through it IP address. When going to the Port A connection of the new blades I can see in the ethernet status that the blades are receiving packets from the network but not sending any. Any thoughts on what can be the problem?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.