Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TelePresence resetting repeatedly

Hi everyone! I'm new to TelePresence and I need some help.

I have a network comprised of MCU4501 with a C20 on the client side.

For some reason, the teleconference disconnects every 100 seconds and reconnects a few seconds later.

I couldn't access MCU4501's logs but was able to review the C20 logs/data captures and noticed the following lines:

RST ACK

FIN ACK

Seems like the MCU's sending RST /  FIN commands, which is then terminating the conference.

My questions are as follows:

1) What triggers the MCU to terminate the conference? i.e. jitter, latency, etc.

2) Since the conference disconnects every 100 seconds, is there a timer setting that may correspond to this cycle?

Thanks!

-Raq

Everyone's tags (3)
4 REPLIES

TelePresence resetting repeatedly

Hi Pramanik,

Do you have any firewall in picture here? could be possible that firewall in the path is doing a TCP connection reset.

Rgds

Alok

New Member

TelePresence resetting repeatedly

Hi Alok,

Actually, there is a firewall (Cisco 3750) on the client side. I can't get rid of this firewall so any way around it? Or what should I look at?

Thanks,

Raq

TelePresence resetting repeatedly

hi Pramanik,

check if you have any TCP/SIP/h.332 packet inspeaction on. if any then stop it.

Rgds,

Alok

New Member

TelePresence resetting repeatedly

Thanks Alok.

I'll double check the settings.

Best,

Raq

278
Views
0
Helpful
4
Replies
CreatePlease to create content