I have checked user and admin guides without much luck. Is there a setting in the Cisco VC environment that allows configuration of how long endpoints will ring before timing out? (Assume no unit has "auto answer" enabled)
Cisco documentation is surprisingly sparse in this area (at least where I have looked). Any guidance is appreciated.
Hi Guy, I know what you mean in FindMe configuration: it is possible to configure ring durations. However, there is no FindMe configured in the environment in this particular case (or that's totally what I would recommend). Thank you for your quick response.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...