Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TMS calls in 'trap log', not in 'call log'

Hi

At TMS (13.0.2 & 13.1.2) we can see calls in {system}/trapLog, but they're not shown in {system}/callLog section.

That happens with some Polycom HDX endpoints, but for others the information appears correctly on both secions. We've compared configs between those that show calls on both sections, and those which not, with no difference.

Thanks

Everyone's tags (5)
3 REPLIES
Cisco Employee

TMS calls in 'trap log', not in 'call log'

Hi

Are all the calls multipoint calls and do you only see this on Polycom units? What if you do a point to point call between this HDX and another system and not the MCU? Do you see the call log for this specific call on the MCU call log?

/Magnus

New Member

Re: TMS calls in 'trap log', not in 'call log'

Hi again,

We've tested with several calls to the MCU and to another endpoints. This happens only in some Polycom HDX.

If we do a call from the system on the previous pictures to a Tandberg MXP, for example, it neither appears in the call log (it does in trap log) of the HDX, but it does on the MXP's. The same happens calling a Polycom VXS.

PS: I suppose you wanted to say "TMS call log" instead of "MCU call log". Calls to MCU from that HDX are shown on the MCU call log.

PPS: Just updated TMS to 13.2, but the problem with HDX persists.

thanks

El mensaje fue editado por: Soporte Tecnico

New Member

Re: TMS calls in 'trap log', not in 'call log'

Hi again,

The problem has been solved.

The source of it was that time wasn't synchronised, so TMS catch calls with an incorrect date and time, and doesn't show them in call log.

Thanks.

Bye

635
Views
0
Helpful
3
Replies