Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

TMS connection

We supervise codec's using TMS.

TMS can not connect the codec after network of codec changed .

We are checking network..

What is port that TMS use when TMS give phonebook to Codec and connect to codec?

then dose TMS use SNMP port only(161,162)? or other port?

i saw information of manual

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tms/install_guide/Cisco_TMS_install_guide_13-2.pdf

Everyone's tags (2)
2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: TMS connection

I would open for Tandberg/Cisco endpoints:

form TMS to the endpoint:

TCP: 20,21,22,23,57,80,443

UDP: 161

from the endpoint to the TMS

TCP: 80, 443

UDP: 162

The corporate phonebook for MXP and TC systems will use port http=tcp/80 or https=tcp/443

depending on what you have configured or whats aailable

Please remember to rate helpful responses and identify

Community Member

TMS connection

Martin,

Where can i find settings for TCP & UDP Ports in TMS ??

Regards

8 REPLIES

Re: TMS connection

I would open for Tandberg/Cisco endpoints:

form TMS to the endpoint:

TCP: 20,21,22,23,57,80,443

UDP: 161

from the endpoint to the TMS

TCP: 80, 443

UDP: 162

The corporate phonebook for MXP and TC systems will use port http=tcp/80 or https=tcp/443

depending on what you have configured or whats aailable

Please remember to rate helpful responses and identify

Re: TMS connection

For Aethra and Polycom endpoints are the same ports listed above?

Thanks

Cisco Employee

Re: TMS connection

Yes, TMS provides the phonebook via http/s 80/443 as Martin is saying. So assuming the endpoints support phonebooks from tms ( dont know about aethra, but certain polycoms does) they have to use the same ports to get the phonebook.

Sent from Cisco Technical Support iPhone App

Community Member

Re: TMS connection

Hello,

For polycom, I have to open FTP (21)  for phonebook (polycom vsx)

Community Member

TMS connection

Martin,

Where can i find settings for TCP & UDP Ports in TMS ??

Regards

Community Member

TMS connection

martin

thanks for your answer

regard

Community Member

TMS connection

Our issue is solved by adjusting MTU size of TMS.(1500->1460)

TMS OS: Windows 2003

is it no problem?

Community Member

TMS connection

Hi,

For polycom below ports are required for phonebook:

TCP Port 3361 – Required for Global Address Books - For 1st and 2nd Gen

TCP Port 3601 – Outbound from device Required for Global Address Books - For VSX, HDX, IPower and ViaVideo I & II Series.

Regards

Sumeet Rakesh

2145
Views
0
Helpful
8
Replies
CreatePlease to create content