we have had to perform an RMA on an MCU, an 8510 the replacement MCU appears to be working without issue, however we now have many conferences that have previously been schedule which TMS is showing as on a deleted system (we had to purge the old MCU to add the new one) is there a method in which we can perform a bulk port of all the conferences scheduled on the previous MCU to bring them onto the new MCU?
You should have done a replace on the old MCU, inputing the new MCU's information. That would have copied over the TMS parameters to the new MCU, but since you've already purged the old MCU from TMS, you can't do this as TMS now doesn't have a record of it.
You could have set TMS to track the old MCU by IP, shutdown the old MCU, and bring the new MCU up with the old IP. TMS wouldn't know the difference since it would be tracking by IP, and not system specific data such as MAC address.
I'm afraid you'll have to touch every conference and update them to use the new MCU, unless there is another way I'm not aware of.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...