Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TMSXE in NON Active Directory Mode

HI,

One of the options for installing TMSXE 3.1.2 is in non AD Mode

Installing with Non-AD mode

To be able to run Cisco TMSXE in Non-Active Directory mode, launch the Cisco TMSXE installer with the

following command line switch :

-NONADCONNECTIONMODE

I can not seem to get this commandline switch to be accepted. Does someone have an example of the correct syntax?

thx,

rf

4 REPLIES
New Member

TMSXE in NON Active Directory Mode

Additional info
Appendix 1

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tmsxe/install_guide/Cisco_TMSXE_install_guide_3-1-2.pdf

anybody have success using this commandline switch?

New Member

TMSXE in NON Active Directory Mode

worked with TAC to get this figured out. The correct syntax is

msiexec /i TMSXESetup.msi NONADCONNECTIONMODE=1

A documentation defect has been opened with ID: CSCul18387

Hopefully that will help someone in the future.

New Member

Hi, is there anyway to revert

Hi,

 

is there anyway to revert back to AD mode after installation?

 

thx
 

Cisco Employee

Not without loss of data. If

Not without loss of data. If you really want to do this, please open a service request with TAC to get dedicated support in assessing your particular deployment.

A word of advice for others who are considering installing TMSXE in non-AD Mode: This option was introduced to support a couple of customers who had very specific requirements. 99.5% of customers do not have Exchange deployments where these conditions apply. Don't install TMSXE in non-AD Mode unless you have discussed it with your Cisco account team and agreed that this is right for you.

Regards,
Kjetil

363
Views
5
Helpful
4
Replies
CreatePlease to create content