Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Touch Pad on EX60/90

WIth the latest software upgrade to TC 5.1.3 I have a locations where their network is retricted to one MAC address per port. Since the software upgrade the EX60/90 is broadcasting two MAC addresses per port; one for the codec and one for the touch panel. Is there a software change to prevent the touch panel MAC address from being broadcasted?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Touch Pad on EX60/90

Hello,

I think you are running into following ddts :

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtz86298

Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?

2 REPLIES
Cisco Employee

Touch Pad on EX60/90

Hello,

I think you are running into following ddts :

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtz86298

Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?

New Member

Touch Pad on EX60/90

Thanks for your prompt response.

496
Views
0
Helpful
2
Replies
CreatePlease login to create content