Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Touch panel recognition.

Hello!

I've looked but haven't found any way to see if the touchpanel for a system is connected, exept looking at it directly.

I need ro verify this remotly. For example via SSH/Telnet, or the gui.

Is there any command that gives this information?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Touch panel recognition.

Hi Olof,

You can login as root to the codec using SSH/telnet and give this command :

[Mubashshir-Akhtar:~] $ netstat

In one of the session, you should see one of the sessions like this :

tcp        0      0 169.254.1.1:65008       endeavour.localnet:52853  ESTABLISHED

Touch Panel is indicated by the IP address 169.254.1.1 when directly connected with the codec. If you're connecting the Touch Panel via LAN, then you can search in the sessions with the IP of the Touch Panel.

Hope this answers your question.

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar
4 REPLIES
Silver

Re: Touch panel recognition.

Hi Olof,

You can login as root to the codec using SSH/telnet and give this command :

[Mubashshir-Akhtar:~] $ netstat

In one of the session, you should see one of the sessions like this :

tcp        0      0 169.254.1.1:65008       endeavour.localnet:52853  ESTABLISHED

Touch Panel is indicated by the IP address 169.254.1.1 when directly connected with the codec. If you're connecting the Touch Panel via LAN, then you can search in the sessions with the IP of the Touch Panel.

Hope this answers your question.

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar
New Member

Re: Touch panel recognition.

Hello again,

Thank you for the answere.

I have a folow up on that one.

From there, is it possible to ssh/telnet to the touchpanel? For example to do a factory reset och see wgat s/w-version it is running?

Regards/

Olof

Silver

Re: Touch panel recognition.

Hi Olof,

I am afraid its not possible in the release software as the port is disabled on the inTouch. You can use the steps below to connect to the Touch Panel :

Connect to inTouch

  • Using ethernet (IP adresse needed): ssh into inTouch from system (must be logged in as root): ssh endeavour. This is disabled in release-software. If you have release software, you need to use the serial cable.
  • or Using serial cable (special serial cable needed): Connect cable to serial port behind sticker on back side and login as root. Baudrate is 115200

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar
New Member

Re: Touch panel recognition.

Ah, I see.

Thank you for quick and helpful answers!

/Olof

554
Views
15
Helpful
4
Replies