Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

TPS can't create new conference, but it should

Hi,

I've a strange problem with a TPS.

Since yesterday, TPS can't create new conferences: error message reports "There are no free port. No remote conferences can be created or new endpoints added to existing conferences"; but that's not true: free ports are present and available.

Licenses are correctly registered and in the "port license status" tab, 4 ports are reported as unused.

This behavior arised yesterday apparently for no reason. Until yesterday, everyhing was working fine.

Due to customer contract (and TPS owner) I can't upgrade TPS software.

I'd like to investigate a bit before opening a case with TAC.

Any suggestion?

Attached some screenshot.

Thanks

Everyone's tags (3)
3 REPLIES
Cisco Employee

TPS can't create new conference, but it should

Hi,

Under the conference status, the video ports should be showing something like 0/8.  But yours is showing 0/0.  1st digit shows how many ports used, and last digit shows how many ports available.  So for your case, is 0, so no ports available.

Perhaps, some settings somewhere is wrong. 

New Member

TPS can't create new conference, but it should

Many thanks for your answer Teck...

That is precisely the problem!!!

Under "status activated features" I have 0/8 licensed ports allocated by supervisor, but under the conference status I have 0/0.

I checked all settings... maybe I missed something


Cisco Employee

Re: TPS can't create new conference, but it should

If you have not done anything before this happen, maybe try to pull out the blade and re insert it again?

Sent from Cisco Technical Support iPhone App

400
Views
0
Helpful
3
Replies
CreatePlease to create content