Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TPS MSE 8710 and MSE 8510 Blade clustering

These may simple questions but I can't seem to find clear cut answers to them. Can you cluster Telepresence MCU MSE 8510 blades with TPS MSE 8710 blades? And if so, what software version do I need to have each blade running? I'm looking to upgrade our from MCU to TPS and just want to make sure I have all the info I need. Thanks.

 

 

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hello Eddie -You can only

Hello Eddie -

You can only cluster blades of the same.  Example, MCU 8510 with other 8510s up to 3 blades, and TPS 8710 with other 8710s up to 4 blades.  The exception to this is if you migrate your MCU 8510 to TPS blades by installing the MCU to TPS software on the 8510, see Running_TS_Software_on_MCU_MSE8510 on how to do that, then those MCU 8510 blades now become and should then be treated as TPS 8710 blades.

All the blades you want to put into a cluster must be running the same version of software.

3 REPLIES
VIP Purple

Hello Eddie -You can only

Hello Eddie -

You can only cluster blades of the same.  Example, MCU 8510 with other 8510s up to 3 blades, and TPS 8710 with other 8710s up to 4 blades.  The exception to this is if you migrate your MCU 8510 to TPS blades by installing the MCU to TPS software on the 8510, see Running_TS_Software_on_MCU_MSE8510 on how to do that, then those MCU 8510 blades now become and should then be treated as TPS 8710 blades.

All the blades you want to put into a cluster must be running the same version of software.

New Member

Hi Patrick, Thanks for the

Hi Patrick,

 

Thanks for the info. This is exactly what I was looking for. Thanks for the quick response.

 

VIP Purple

No problem.Don't forget to

No problem.

Don't forget to mark your question as answered, for others that might have the same issue.

315
Views
0
Helpful
3
Replies