Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

TTC5- 06 Mic specification

Does anyone know the specification of

TTC5- 06 Mic

the microphone for Telepresence C20 / SX20

3 REPLIES
Cisco Employee

TTC5- 06 Mic specification

Cisco Performance Mic 20 Specifications

  • Intuitive mute function directly on microphone with status indicator
  • Omni-directional, boundary microphone.
  • Excellent RF resistance and low self noise.
  • 3.5 mm four-pin mini-jack connector and 7.5 meter cable.
  • Robust and well suited for long-term meeting room use.
  • Designed by Cisco.


Technical details:

  • Directivity: Omni-directional (uniform in hemisphere above boundary)
  • Frequency response: 80-15 kHz | 80-3 kHz ± 3dB | 80-15 kHz ± 6dB
  • Sensitivity: -35dB ±3dB rel. 1V/Pa.
  • Max SPL: 110dB (3% THD @ 1kHz)
  • Self-noise: < 29 dBA , > 65 dB SNR (Signal to Noise Ratio)
  • Mic. output: Differential
  • Phantom power: 12 V
  • Output connector: 4 pin 3,5 mm mini-Jack (Shield: GND / ring 2: muter detect / ring1: signal - / Tip: signal +)
New Member

Is there an extension cable

Is there an extension cable from Cisco (male to female) for these mics and if so, is there a length restrictions before any issues occur that would affect quality or functionality?

If there's a Cisco extension please provide the part #.

 

 

VIP Purple

Yes, there is a 10m extension

Yes, there is a 10m extension cable available from Cisco, part number is CAB-MIC20-EXT=.

The microphone and cable were only designed for a single extension cable, however, if you make your own extension with quality cabling (22/4 gauge shielded audio cable) and connectors you can get a longer distance (length will vary depending on the voltage drop characteristics of the cable you choose).

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
4514
Views
0
Helpful
3
Replies
CreatePlease to create content