Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UC and VCS Integration

Dears,

I want to call from CTS endpoint to my cisco IP phone, so i need to create a SIP trunk on CUCM to pointing to VCS, what configuration i have to do on VCS for the same.

Also i want to know what blanks i have to fill in on  SIP trunk window of CUCM.

I am a fresher for VCS and UC.

Thanks

3 REPLIES

UC and VCS Integration

When you say "CTS Endpoint" do you mean an endpoint registered to CUCM or VCS? If they are both registered to CUCM you don't need a SIP trunk.

If you mean a video endpoint registered to VCS, check the CUCM to VCS deployment guide here - it gives you step by step instructions:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Cisco_Unified_Communications_Manager_Deployment_Guide_CUCM_8_9_and_X7-2.pdf

Please rate and mark answer as appropriate.

UC and VCS Integration

Hi Jack,

you can go thorugh the deployment guide suggested by Nick in above post. normally the blanks on CUCM window SIP trunk point towards VCS ip.

please also note to sggregate your dial plan for VCS and CUCM.

Rgds

Alok

Bronze

UC and VCS Integration

some questions need to be answered:

what version of CUCM and VCS have you deployed?

is your VCS clustered?

are trying to establish a SIP trunk using TLS?

what type of endpoints and where are they registered at?

there are a few deployment guides released to public but you need to be specific in order to use the right one.

regards, Ahmad

285
Views
0
Helpful
3
Replies