Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

[URGENT]Problem DTMF Pin

Hi people,

I have a big problem here and I don't know where I start to solve this issue.

Topology: 
Company A has 2 building and 1 VCS that works for both building. 
Company B has 1 building, 1 VCS, 1 TP Server and 1 MCU Codian

Both VCS are connected through a SIP Trunk

 

 

The problem:

The communication works correctly point to point from the two building from "Company A" to "Company B", everything works correctly. 
When we perform a call to the TP Server / MCU from building A (company A) to Company B everything works well. No problems here.


However, when we performed a call to the TP Server / MCU from the building B (company A) to  company B, the DTMF is not sent, if we create a room with PIN for example, it is not possible to connect the TP Server / MCU, because the company B does not receive the digits.

 

POINT TO POINT

Building A --> Company B = OK

Building B --> Company B = OK

 

Muilt Point

Building A --> Company B = OK

Building B --> Company B = The DTMF wasn't send

The building A have the same equipment, but TC 5.x and in the building B is TC 6.x

 

Can any one help me?

 

1 REPLY
VIP Green

To see whether it's a TC

To see whether it's a TC software issue - have you tried a TC5/6 endpoint in the other location from where it works?  Ie, try a TC6 in Building A and/or a TC5 in Building B.

In any case, I'd recommend you upgrading the TC5 (and TC6 if they're less than TC6.1) due to the multiple vulnerabilities in the software: Cisco-SA-20130619-TPC.

And even more so, to version TC5.1.11, TC6.2.1 or TC7.1.1 to address the OpenSSL Heartbleed issue.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
78
Views
0
Helpful
1
Replies