Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Use the 2.nd ethernet port on C.60 Codec for controling.

Hi.

Is it possible to use the 2.nd ethernet port on a c60 codec for sending x.commands to the codec.

My problem is that the controlsystem (AMX) is on a separate, internal network.

Regards.

Henning Telving

Everyone's tags (2)
1 REPLY
Silver

Use the 2.nd ethernet port on C.60 Codec for controling.

Hi Henning,

The second ethernet port is only used for connecting the Touch Panel to the codec directly so that it can be paired. It cannot be used to send xcommands.

I dont think you can use the AMX control on a different network. I would recommend that you visit the link below for better assistance for AMX :

http://developer.cisco.com/web/tandberg-developer/

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar
315
Views
0
Helpful
1
Replies
CreatePlease login to create content