Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Using Cisco InTouch to trigger event on a Crestron controller?

Is it possible to have the Cisco InTouch panel/system trigger an event on a ethernet enabled Crestron controller?
(The codec does not have GPIO outputs so I believe it has to be done over ethernet if possible)

-Torje

2 REPLIES

Using Cisco InTouch to trigger event on a Crestron controller?

If the codec can be connected to the Crestron on a serial I/O then you could use a feedback output from the codec based on a setting change from the InTouch.

Otherwise the only way I would say this is possible is if the InTouch or CODEC outputs feedback over Ethernet that then could be used to trigger the event you desire.

Community Member

Using Cisco InTouch to trigger event on a Crestron controller?

Actually, I am shocked I did not think about that... I was too hung up in the Cisco actually sending a command to the Crestron... The Crestron should just monitor the settings change like you say. Should do the trick. Thanks

319
Views
0
Helpful
2
Replies
CreatePlease to create content