Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VCS control H323 call log shows no route to destination

I am placing a call from a C60 which is registered to a VCSc. The call is rejected and it says:

H323 <-> H323No route to destination Unreachable destinationVCS

If I place a SIP call to the same destination it works. The call search history also shows

H323 (Setup) No route to destination - Unreachable destination

H323 (ARQ) Found

Any help would be greatly appreciated and I always give good points for good help.

Thanks,

Alex

Everyone's tags (4)
2 REPLIES

VCS control H323 call log shows no route to destination

You need to give us a bit more information; i.e. is this to another end-point registered to the same VCS-C or to an external end-point? Does it only happen when you call that particular end-point? Is there a firewall in the picture?

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Please rate replies and mark question(s) as "answered" if applicable.
New Member

VCS control H323 call log shows no route to destination

I looked at the VCSe and the IP configuration was configured for NAT.  I took the NAT configuration out and that worked for my particular setup.  The configuration guide was very helpful.

Thanks,

Alex

1648
Views
3
Helpful
2
Replies
CreatePlease login to create content