Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VCS Starter Pack Express 7.0.1 without DUAL NIC / Network configuration

Hello Community,

can you please explain me, how I put a VCSESTRTPACK to Internet? Just put the public IP-Address to the Interface configuration? I just have one public IP, so I have to NAT? Or is it possible to make it work. I want to register devices from outside over the Internet. Some endpoints are behind NAT.

How is the routing configuration and the network deployment?

I will put the VCSESTARTPACK for register server from external endpoints over the internet.

And for internal service use a MCU and TMS. So I nedd communication from intern and extern to my VCSESTARTPACK. Is it possible to connect a internal VCSC to it to increase registrations?

 

Thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Duplicate posts.   Go here:

Duplicate posts.  

 

Go here:  https://supportforums.cisco.com/discussion/12263321/vcs-starter-pack-express-update-vcse

2 REPLIES
Hall of Fame Super Gold

Duplicate posts.   Go here:

Duplicate posts.  

 

Go here:  https://supportforums.cisco.com/discussion/12263321/vcs-starter-pack-express-update-vcse

New Member

Before we want to update the

Before we want to update the STARTPACK to a VCSE, we want to put it on the public IP. How does it works? Just configure the Interface with a static public IP?

So we want to build up the system without DUALNIC first. I can put it on the DMZ or outside. If I configure a public IP on the VCS I don´t need the DUAL feature, right?

How can I conig my network to provide the public IP to the VCS? We have a DSL PPPoE WAN connection.

 

 

56
Views
0
Helpful
2
Replies
CreatePlease to create content