virtual TelePresence not showing any screen licenses on Conductor
I have a demo Conductor and virtual TelePresence server. I have the default license that comes with Conductor installed. The virtual TelePresence server has two feature keys installed (VM Activation and TS Screen Licenses). I do not have the TLS Encryption key installed yet. When I look at the Conductor it displays the vTelePresence Server and it shows enabled but under call resources I have the following:
Call resources: Screen licenses=0, Calls=200
Allocated: Licenses 0% Calls 0%
In user: Licenses 0% Calls 0%
Unallocated:Licenses 100% Calls 100%
Number of calls: 0
My TS screen licenses feature key on vTS says "TS Screen Licenses x 6" but they don't show up on Conductor
I got the Encryption Key but that just allowed me to activate 443 and 5061. Right now I don't have any reservations for the CPUs in place. Can someone tell me what it should be? I didn't install the OVA so I am not sure what it defaults to.
So I was running vTS - 4.0(2.8) and I reboot back to version 4.0(1.57) and now I have 4 screen licenses. That is still with no reservations on the HW. Not sure what is going on. Need to talk to Cisco about this.
i found the problem on my side. it seems that if you don't meet the CPU requirements of the vTS (minimum 2,4 GHz) it gives no error message, but it also does not activate the screen licenses, even though you activated it correctly.
so for your installation: please activate the encryption key, configure conductor to use https and check if you meet the requirements for the product, then it should activate the screen licenses.
Tested reference configurations and minimum specifications can be found in the prerequistites section of the vTS installation guide. We recommend all customers experiencing issues since upgrading to 4.0(2.8) check that their system meets the minimum requirements, especially regarding processor model.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...